INSTRUCTIONS FOR RIGHT SERVICING
Use only oils for oil-pressure systems.
Look after the system and make sure that its parts are always very clean.
Do not mix oils with different chemical and physical characteristics.
After a day of work and/or according to the use it is necessary to lubricate pins, balls, ball joints, and every other articulated joint of the cylinders. It is also necessary to clean the grease in excess.
Do not clean the cylinder with high-pressure hydropolishing machines.
Inspect fasteners every week (screws, nuts, seegers, pins, etc).
Inspect every day and/or according to the use the protective casing and the clamps. Do not remove them, and replace them in case of breakage, also if partial.
NOTICE: It is forbidden to dismount cylinders under warranty, because it is essential and only condition that every necessary taking apart of the cylinders must be made by T.M.A. general partnership and/or by qualified workshops, after written authorization of T.M.A. general partnership that will provide relevant instructions. (If the buyer and/or user will act differently from this directions, he will lose the warranty)
USE ONLY ORIGINAL SPARE PARTS